5-1 Cut off the Applicable Ports
Cut off the ports that you plan to use, either before or after placing the Filter Tank.

Note: Filtrific provides different port size options with each Filter Tank. Make sure the Flex-Coupling included with the kit fits over the port before cutting.



5-2 Excavate for the Filter Tank & Any Expansion Tanks


Allow room for 1" of compacted sand below the Filter Tank. This cushions the bottom of the Filter Tank and also makes leveling easier.



5-3 Position the Filter Tank & Any Expansion Tanks
 


5-4 Level the Filter Tank
Level the Filter Tank and backfill up to where the T40SP Side-Pod(s) will rest. Add a layer of compacted sand and slide the T40SP Side-Pod(s) into place.



5-5 Connect the Expansion Tank Manifold to the Filter and Expansion Tanks
Connect the Filter Tank to any additional Expansion Tanks.


The T75F (shown right) has a T40SP Side-Pod connection port on the front of the tank. The T40F (not shown) connects to the T40SP Side-Pod using the back-lower port labeled "More Capacity."


Place rocks for the waterfall
Back to previous section <


Connect the waterfall pump
and discharge
Forward to the next section>


Shop for backyard waterfall kits >


Back to installation guide <
Copyright Berkey Supply 2006 © • website advertising by Mobile Penguins website advertising by Mobile Penguins Links