6-1 Run the Intake Pipe to the Water Feature
At Grade
Step 1: Excavate the intake trench from the edge of the
liner to the Filter Tank.
If the Filter Tank is level with the
water feature, dig the intake trench so the
pipe will be level.
Below Grade
Step 1: When the top of the Filter Tank is placed lower
than the rim of the vanishing pool, the rim of the pool
becomes your reference pin. To find the penetration point of the intake
pipe, measure down 8-3/4" for 4" and 6" pipe and 10-3/4" for 10" pipe.
Elbow down accordingly to connect to the Filter Tank intake port.
Note: The intake pipe should be long enough to extend
inside the water feature 3" for 4" IPS pipe, and 4" for
6" IPS pipe.
Step 1: Excavate the intake trench from the edge of the
liner to the Filter Tank.
If the Filter Tank is level with the
water feature, dig the intake trench so the
pipe will be level.
Below Grade
Step 1: When the top of the Filter Tank is placed lower
than the rim of the vanishing pool, the rim of the pool
becomes your reference pin. To find the penetration point of the intake
pipe, measure down 8-3/4" for 4" and 6" pipe and 10-3/4" for 10" pipe.
Elbow down accordingly to connect to the Filter Tank intake port.
Note: The intake pipe should be long enough to extend
inside the water feature 3" for 4" IPS pipe, and 4" for
6" IPS pipe.
6-2 Run the Intake Pipe Through the Liner and Connect to the
Fixed Skimmer
6-3 Run the Intake Pipe Through the Liner and Connect to the
Fixed Skimmer (cont'd)
Fixed Skimmer
6-3 Run the Intake Pipe Through the Liner and Connect to the
Fixed Skimmer (cont'd)
